Yes, not only is TF1 compatible with all products, it also works as a perfect dosing place for's 500-liter Express Series "F" exporter and spray.

The capture efficiency at the first filter passage is 97%.

TF1 flow dynamics ensure that the magnetic particles are fed closer to the magnet and the magnet can therefore be more easily pulled and tightened. In conventional technology, the magnet acts against the centrifugal force, and the particles collect in the center, which is harder for the magnet.

Yes, installing TF1 is simple, fast and intuitive. It is mounted directly into the pipe without the need for additional fittings.

TF1 is available in four versions, for 22 mm and 28 mm pipes, respectively. for 3/4 "and 1" outer thread ..

More than 400 g of sludge (depending on the type of sludge).

No.

Yes, the filter is designed for use with any boiler or heating system.

Yes, TF1 valves can be used as input points for Powerflow MKII. Simply disconnect and select TF1 and pressure-relief valves. Flush Buddy is a magnetic cleaning system recommended by.

Yes.

Yes, simply locate the magnet in place by stretching the safety tape through the holes in the magnet shell and the magnet cover and pulling it.

Yes, TF1 can be placed on both vertical and horizontal pipes.

Yes, if a plumber has a pacemaker, he must take care when working with TF1.

The TF1 dimensions are approximately 300 mm x 100 mm.

9 000 Gaussov.

Magnetism decreases with temperature, so the TF1 magnet has been designed to produce much higher operating temperatures (up to 150 ° C) than the average operating temperature of the central heating system = 80 ° C.

Two years.

Yes, TF1 can be cleaned in a few seconds, the magnet can be easily removed and the filter can be flushed with a drain valve.

TF1 differs from other filtration systems by being the only one to capture both magnetic and non-magnetic particles without the need for barrier filtration technology.

TF1 removes magnetic particles and sediments from the heating system and thus reduces the risk of deposits in the heat exchanger. It eliminates the blockage of the pipes and components by deposits, thus ensuring the efficiency of the boiler and thus reduces the heating costs.

In the initial period after installing it more often, as needed, later on for long-term use once a year.

No, TF1 has the benefit of "non-contact" cleaning, but with proper health and safety procedures, recommends the use of waterproof gloves when cleaning TF1.

From a specially selected grade of nylon reinforced with glass fibers.